Z31 Fuel Pressure Regulator and Fuel Temperature Sensor
On the Z31 300ZX, the fuel pressure regulator and fuel temperature sensor are a single unit. Together they help the ECU control fuel pressure and fuel delivery.
The two parts can't be separated. If either one fails, replace the regulator and sensor as an assembly; the FSM says not to remove the sensor from the regulator.
Warning: do this work at your own risk. We are not responsible for any problems or damage caused by your own work.
How It Works
Fuel Pressure Regulator
The regulator has a diaphragm with fuel pressure on one side and intake manifold vacuum on the other. It restricts the fuel return line to hold the fuel pressure at a set amount above manifold pressure, so the injectors deliver the same amount of fuel for a given pulse at any engine load.
Fuel Temperature Sensor
The fuel temperature sensor is a thermistor built into the regulator; its resistance drops as the fuel gets hotter. When the fuel temperature rises above a set level, the ECU increases the amount of fuel injected to cool the fuel in the rails and prevent vapor lock. Early Z31s also had an injector cooling fan for the same reason.
The ECU also uses fuel temperature to run the pressure regulator control solenoid, which raises fuel pressure for hot restarts.
Common Problems
- ECU code 42 (fuel temperature sensor). On 1987 models it's code 41. See Z31 ECU Codes.
- Hard starting when hot, or rough running after a hot soak
- A leaking regulator diaphragm: fuel in the vacuum hose, a fuel smell, or running rich
- Low or unstable fuel pressure
Testing the Fuel Temperature Sensor
- Check at the ECU. Disconnect the ECU's 20-pin connector and measure the resistance between terminal 15 and ground:
If it's in range, the sensor and wiring are good.Fuel temperature Resistance Above 20°C (68°F) Below 2.9 kΩ Below 20°C (68°F) Above 2.1 kΩ - Check the harness between the ECU and the sensor for continuity. Repair it if there's a break.
- Check the sensor by measuring its resistance directly at the regulator:
Temperature Resistance −10°C (14°F) 7.0–11.4 kΩ 20°C (68°F) 2.1–2.9 kΩ 50°C (122°F) 0.68–1.0 kΩ 80°C (176°F) 0.26–0.39 kΩ 100°C (212°F) 0.18–0.20 kΩ - If the sensor is out of spec, replace the fuel temperature sensor and pressure regulator as an assembly. If the sensor is in spec and the wiring is good, the FSM points to the ECU.